Now that was a nice easy start wasn't it?
Deselect the baseboard. Click on the Draw Tool.
Single Line, Width 7, Antialias, Create As Vector.
Draw along the top of the baseboard, following the angle. Convert
to a Raster Layer.
Brightness/Contrast, 60/10. Trim off any excess.
Change the Draw Tool Width to 5.
Draw along the bottom of the baseboard, following the angle.
Convert to a Raster Layer.
Brightness/Contrast, -20/10. Trim off any excess.
Make the headboard layer active. Select the headboard with
the Magic Wand.
Flood Fill with your wood Pattern. Invert the
Selection.
Effects/3D/Outer Bevel. Custom Preset: Comforter 1
(You will be using this Preset later too.) Leave Selected.
Selections/Modify/Expand. Expand by 1 pixel.
Leave Selected.
Effects/Blur/Gaussian Blur. Radius: 0.50
[ Page 1 ]
[ Page 2 ]
[ Page 3 ]
[ Page 4 ]
[ Page 5 ]
[ Page 6 ]
[ Page 7 ]
[ Page 8 ]
[ Page 9 ]
[ Page 10 ]
[ Page 11 ]
[ Page 12 ]
[ Page 13 ]
[ Page 14 ]
[ Page 15 ]
[ Page 16 ]
[ Page 17: Vector Bed ]
[ Page 18: Vector Bed ]
[ Back To Furniture ]
[ PSP7 Listings ]