If you don't want to go through all those ruffles steps again for the side ruffles, copy and paste one of your front ruffles layers as a new layer.  Rotate to the right, 20 degrees.  Make sure that All Layers is unchecked.

Move this new ruffle layer over to where it goes.  Click on the Deform tool.  You then want to left click and hold the click down on either the top or bottom square on the right side of the Deform area.  Squeeze the box inward to push the ruffles over.  If you end up with an odd angle, you didn't squeeze correctly, so Undo and try again.

After you finish the Deform, go to Effects/Sharpen/Unsharp Mask, settings below.
Then copy and paste this ruffle layer as a new layer.
Name your new layers side ruffle 1 and side ruffle 2.

On the Layer Palette, drag the side ruffles below the sideboard layers.
Delete the side ruffle template piece.

It's time to make the bedpost.

[ Page 1 ]   [ Page 2 ]   [ Page 3 ]   [ Page 4 ]   [ Page 5 ]   [ Page 6 ]   [ Page 7 ]   [ Page 8 ]   [ Page 9 ]   [ Page 10 ]   [ Page 11 ]   [ Page 12 ]   [ Page 13 ]   [ Page 14 ]   [ Page 15 ]   [ Page 16 ]   [ Page 17: Vector Bed ]   [ Page 18: Vector Bed ]   [ Back To Furniture ]   [ PSP7 Listings ]