Using the Vector Bed Template
Using the Vector Bed Template
When you change the Fill to Pattern, it will automatically put the standard pattern in. Click on that pattern to bring up the choice of patterns. The wood pattern you have open in PSP will be at the top of the list. Pick it and say ok. If you need to change the Angle or the Scale of the pattern, do so before saying ok. For the headboard, this piece of wood is fine at Angle 0 and Scale 100. When you say OK on this window, the Vector Properties window will still be up. Make sure that Visible and Antialias are checked, then say OK.
Now you could have also picked the wood for the Stroke, but it's easier to just set Stroke to Null. In the future though, if you want something interesting with two different patterns or colors, you would use the Stroke.
Now go ahead and fill the baseboard and sideboard with the wood the
same way you filled the headboard.
Also fill your comforter and sheets layers.
You can now convert those Vector layers you have filled to Raster layers. Look at your Layer Palette again. You can right click on each of the layers you have filled and convert them easily to a Raster Layer.
Note for Vector Pillow: When you go to fill the Piping, Use the Stroke box, not the Fill box. Null the Fill box out.
[ Page 1 ]
[ Page 2 ]
[ Page 3 ]
[ Page 4 ]
[ Page 5 ]
[ Page 6 ]
[ Page 7 ]
[ Page 8 ]
[ Page 9 ]
[ Page 10 ]
[ Page 11 ]
[ Page 12 ]
[ Page 13 ]
[ Page 14 ]
[ Page 15 ]
[ Page 16 ]
[ Page 17: Vector Bed ]
[ Page 18: Vector Bed ]
[ Back To Furniture ]
[ PSP7 Listings ]